Control Board Settings

The Control Board  is a digital read-out board. This board offers a wide variety of settings to operate the unit. This part can be removed from the unit by loosening the two outside screws and pulling the board back to the inside of the stove. The rear access panel should be removed prior to removing the control board. A 5-amp "quick-blow" fuse is used on this Control Board.

NOTE: The bottom three control buttons are preset at the factory and should not require any changes. See "Operating Instructions" and "Daily Operation" section of the manual for instructions on other Control Board settings.

The heat range up and down buttons control the amount of fuel fed into the fire by controlling the length of time the top auger runs in each cycle. the blower speed up and down buttons control the speed of the room air blower.

Circuit Board

Continue to Thermostat page

If you have any further questions or concerns, please contact Customer Service at:

Copyright © 2005   England's Stove Works, Inc.   All rights reserved.
Revised:  11/07/2008

This web site, including all pictures, description and information of any sort contained therein is intended for the sole use of customers and representatives of England's Stove Works, Inc. No part of this web site or the information contained therein may be reproduced without express written permission from England's Stove Works, Inc..